Owner`s manual

AJP PR5 User’s manual – 3
rd
Edition – Rev 1 Page
25
FRONT WHEEL REMOVAL
Front wheel dismounting
To remove the front wheel, jack the
motorcycle up on its frame so that the
front wheel no longer touches the
ground.
Loosen the two screws (1) on left leg of
front fork, unscrew front axle (2), hold
the wheel and remove front axle.
Remove front wheel carefully from the
fork.
If it is necessary to remove it, measure
with a caliper the distance out of axle
holder, in order to place it correctly later
in assembly.
Note: threaded bush (3) of front wheel
should not be untighten or removed
front right leg, once that is the part that
determines the position of front wheel
on the front fork.
! CAUTION !
Do not operate hand brake lever
when front wheel has been
removed.
Front wheel mounting
Place front wheel between front fork
sleeves in a way that brake disc is
between brake pads.
Tight front axle and tight fixation
screws.
Check if front wheel rotates freely
without any restrain.
! WARNING !
After mounting front wheel, actuate
hand brake lever until pressure
point is established.
Keep brake discs free from oil and
fatty materials, otherwise braking
effect will be strongly reduced.
REAR WHEEL REMOVAL
Dismounting rear wheel
Jack the motorcycle up on its frame so
that the rear wheel no longer touches
the ground. Loosen the collar nut (1) in
the right side, hold the rear wheel and
pull out the wheel spindle (2) by the left
side until the rear wheel is free but the
brake calliper support is still held in the
swing arm.
Push the rear wheel as far forward as
possible, take out the chain from the
rear sprocket and carefully remove the
wheel carefuly from the swing arm.
Mounting rear wheel
To mount rear wheel, follow the above
procedure in reverse order, being
careful to place the brake disc correctly
1
2
3
3
2
1