User Manual

WallSwitch, with rmware version below 5.54.1.0, only works in bistable mode with
a normally open contact.
At low loads (up to 25 W), current and power consumption indications may be displayed
incorrectly due to hardware limitations.
Connecting to the hub
Before connecting the device:
Only users with administrator rights can add a device to the app.
To pair WallSwitch with the hub:
• Normally open (NO) — the contacts close when the relay is activated and open
when the relay is inactive.
How to �nd out the �rmware version of the device?
1. Switch on the hub and check its Internet connection (the logo glows white or
green).
2. Install the . Create the account, add the hub to the app, and create at
least one room.
Ajax app
3. Make sure that the hub is not armed, and it does not update by checking its
status in the Ajax app.
1. Click Add device in the Ajax app.
2. Name the device, scan it, or enter the QR code manually (located on the case
and packaging), select the room.