User Manual

BASE 2200
28 | English
Red No valid SIM card detected.
Check if the PIN of the card is
still active and remove it.
Yellow SIM card detected, possible
error: No network connection,
card locked, possible
compatibility problems,
connection to the network
insufciently ensured.
Green The card has been successfully
detected and has a connection
to the network.
SIM card status in the App:Open the battery ap on the underside of
the BURGprotect BASE and switch the device
to the OFF position using the slide switch.
Before inserting the SIM card, activate and
deactivate the PIN at your provider, e.g. by
inserting the SIM card into your smartphone.
Insert the SIM card in the slot of the
deviceside.
As SIM card, use a standard GSM/WCDMA/
LTE SIM card and no CDMA SIM card! If you
have a Nano SIM or Micro SIM card, please
use a corresponding adapter.
Note:
• Use a SIM card capable of SMS and not a
data SIM card.
• An internet connection is necessary for
the rst conguration, this is not carried
out via the SIM card.
• Deactivation / activation of the system
via SMS is not possible. For this purpose,
please use the respective accessories,
e.g. CONTROL or KEYPAD.
Insert the SIM card (optional)
The BURGprotect system serves as a deterrent
against burglars and other criminals as well as
records of suitable sensor data and
information sharing. The product has been
designed such that it is as easy to install as
possible and can be operated by end
customers that also have limited IT or system
knowledge.
The system cannot prevent a break-in, theft,
re, water ingress or where applicable, other
life-threatening situations. It serves only as
support for the early detection of incidents.
Safety instructions
The transmission of information (e-mail, push
notications, etc.) is bound to a network /
internet connection as well as other factors
that cannot be inuenced by the manufacturer
(provider, connection rate / signal strength,
etc.) and service of third-party providers
(©Goolge and ©Apple).
The signal range depends strongly on the local
circumstances. Test the correct function of the
system after the installation of each accessory
part.
Check the function of the system and their
components at regular intervals.
IMPORTANT NOTE: Test the correct
function before completing the
commissioning.
BA BURGprotect_BASE 2200_03-2019_03.indd 28 10.04.2019 16:24:35