Specifications
OM-229 158 Page 2
FIRE OR EXPLOSION hazard.
Do not overheat parts.
Watch for fire; keep extinguisher nearby.
Keep flammables away from work area.
Do not locate unit on, over, or near combustible surfaces.
Do not install unit near flammables.
Do not operate where the atmosphere may contain flammable
dust, gas, or liquid vapors (such as gasoline).
After completion of work, inspect area to ensure it is free of
sparks, glowing embers, and flames.
Use only correct fuses or circuit breakers. Do not oversize or by-
pass them.
INDUCTION HEATING can burn.
Do not touch hot parts bare-handed.
Allow cooling period before handling parts or
equipment.
Do not touch or handle induction head/coil
during operation.
Keep metal jewelry and other metal personal items away from
head/coil during operation.
To handle hot parts, use proper tools and/or wear heavy, insu-
lated welding gloves and clothing to prevent burns.
1-3. Additional Symbols for Installation, Operation, and Maintenance
FALLING EQUIPMENT can injure.
Use handle and have person of adequate
physical strength lift unit.
Move unit with hand cart or similar device.
For units without a handle, use equipment of
adequate capacity to lift and support unit.
Keep equipment (cables and cords) away from moving vehicles
when working from an aerial location.
If using lift forks to move unit, be sure forks are long enough to
extend beyond opposite side of unit.
Follow the guidelines in the Applications Manual for the Revised
NIOSH Lifting Equation (Publication No. 94−110) when manu-
ally lifting heavy parts or equipment.
FLYING METAL OR DIRT can injure eyes.
Wear approved safety glasses with side
shields or wear face shield.
MOVING PARTS can injure.
Keep away from moving parts such as fans.
Keep all doors, panels, covers, and guards
closed and securely in place.
Have only qualified persons remove doors, panels, covers, or
guards for maintenance and troubleshooting as necessary.
Reinstall doors, panels, covers, or guards when maintenance is
finished and before reconnecting input power.
ELECTRIC AND MAGNETIC FIELDS (EMF)
can affect Implanted Medical Devices.
Wearers of Pacemakers and other Implanted
Medical Devices should keep away.
Implanted Medical Device wearers should consult their doctor
and the device manufacturer before going near arc welding, spot
welding, gouging, plasma arc cutting, or induction heating
operations.
OVERUSE can cause OVERHEATING
Allow cooling period.
Reduce output or reduce duty cycle before
starting to heat again.
Follow rated duty cycle.
STATIC (ESD) can damage PC boards.
Put on grounded wrist strap BEFORE handling
boards or parts.
Use proper static-proof bags and boxes to
store, move, or ship PC boards.
H.F. RADIATION can cause interference.
High-frequency (H.F.) can interfere with radio
navigation, safety services, computers, and
communications equipment.
Have only qualified person familiar with electronic equipment per-
form this installation.
The user is responsible for having a qualified electrician promptly
correct any interference problem resulting from the installation.
If notified by the FCC about interference, stop using the equip-
ment at once.
Have the installation regularly checked and maintained.
Keep high-frequency source doors and panels tightly shut.
READ INSTRUCTIONS.
Read and follow all labels and the Owner’s
Manual carefully before installing, operating, or
servicing unit. Read the safety information at
the beginning of the manual and in each
section.
Use only genuine replacement parts from the manufacturer.
Perform maintenance and service according to the Owner’s
Manuals, industry standards, and national, state, and local
codes.