Users Manual

Model name:
Ajax DoorProtect
Quick Start Guide
Before using the device, we strongly
recommend reviewing the User Manual
on the website.
Product name: Magnetic opening detector
DoorProtect is a wireless magnetic opening detector
that features a connector for an external detector.
Complete Set: 1. DoorProtect; 2. SmartBracket mounting panel;
3. Battery CR123A (pre-installed); 4. Big magnet; 5. Small magnet;
6. O ut sid e - mou nte d ter min al cl amp ; 7. In sta lla tio n ki t; 8 . Qu ic k St ar t G uid e.
FCC WARNING STATEMENT NOTE:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed
and operated with minimum distance between 20cm the radiator your body: Use only the
supplied antenna.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN IN-
CORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
Warranty: Warranty for Ajax devices is valid for two years after the
purchase date and does not apply to the supplied accumulator. If the
device does not work correctly, you should irst contact the support
service—in half of the cases, technical issues can be solved remotely!
ajax.systems/
support/devices/
doorprotect
Sensor Sealed contact reed relay
Detector actuation threshold
1 cm (small magnet)
2 cm (big magnet)
Tamper protection Yes
Socket for connecting
wire detectors
Yes, NC
Frequency range
902-928 MHz FHSS
(complies with part 15 of the FCC rules)
Maximum RF output power 6.19 mW (limit 20 mW)
Radio signal range Up to 1,200 m (in a line of sight)
Power supply 1 battery CR123A, 3 V
Battery life Up to 7 years
Operating temperature range From -10°С to +40°С
Operating humidity Up to 75%
Dimensions Ø 20 х 90 mm
Weight 29 g
The full text of the warranty is available on the website:
ajax.systems/warranty
User Agreement: ajax.systems/end-user-agreement
Technical support: [e-mail]
Manufacturer: “AS Manufacturing” LLC.
Address: 5 Sklyarenka Str., Kyiv, 04073, Ukraine.
www.ajax.systems
EN
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that
may cause undesired operation of the device.
FR
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.