User Manual
Motion Detector If active, motion detector will be active
Motion Detector Sensitivity
Choosing the sensitivity level of the motion
detector:
Motion Detector Always active If active, the detector always registers motion
Glass Break Detector If active, glass breaking detector will be active
Glass Protection Sensitivity
Choosing the sensitivity level of the glass
detector:
Glass Protection Always Active
If active, the detector always registers glass
breaking
Alert with a siren if motion detected
If active, and are
activated when the motion detected
Alert with a siren if glass break detected
If active, HomeSiren and StreetSiren are
activated when the glass break detected
Jeweller Signal Strength Test
Switches the detector to the signal strength test
mode
Detection Zone Test Switches the detector to the detection area test
Attenuation Test
Switches the detector to the signal fade test
mode (available in detectors with rmware
version 3.50 and later)
Temporary Deactivation Allows the user to disconnect the device
without removing it from the system.
Two options are available:
High
Normal
Low
High
Normal
Low
HomeSiren StreetSiren
Deactivate entirely — the device will not
execute system commands or participate in
automation scenarios, and the system will
ignore device alarms and other notications