User Manual

For detection and pairing to occur, the detector should be located within the
coverage of the wireless network of the hub (at a single protected object).
Request for connection to the hub is transmitted for a short time at the time of
switching on the device.
If connection to the Ajax Hub failed, switch off the detector for 5 seconds and
retry.
The detector connected to the hub will appear in the list of devices of the hub in
the application. Update of the detector statuses in the list depends on the
device inquiry time set in the hub settings, with the default value – 36 seconds.
Connecting the Detector to Third Party Security Systems
To connect the detector to a third party security central unit using the
or integration module, follow the recommendations in the manual
of the respective device.
States
Parameter Value
Temperature
Temperature of the detector. Measured on the
processor and changes gradually
Jeweller Signal Strength
Signal strength between the hub and the
detector
Battery Charge
Battery level of the detector, displayed in
increments of 25%
Lid
The tamper mode of the detector, which reacts
to the detachment of or damage to the body
Delay when entering, sec Delay time when entering
Delay when leaving, sec Delay time when exiting
Routed through ReX Displays the status of using the ReX range
uartBridge
ocBridge Plus
1. Devices
2. CombiProtect