User Manual
The electret microphone is responsible for glass break detection. The intelligent
event registration system requires a sequence of sounds of a specic nature –
rst dull blow, then ringing sound of falling chips, which prevents accidental
actuation.
CombiProtect does not detect glass breaking if the glass is covered with any lm:
shockproof, sunscreen, decorative or other. In order to detect the breaking of this type
glass, we recommend using a wireless opening detector with shock
and tilt sensor.
After actuation, the armed detector immediately transmits an alarm signal to the
hub, activating the sirens and notifying the user and security company.
To arm Ajax security system (including Ajax CombiProtect detector) you can
use , key fob or .
If before arming the system, the detector has detected motion, it will not arm
immediately, but during the next inquiry by the hub.
Connecting the Detector to the Ajax security system
The detector is connected to the hub and set up via the Ajax Security system
mobile application. To establish connection please locate the detector and the
hub within the communication range and follow the device adding procedure.
Before starting connection:
DoorProtect Plus
Ajax Security System app SpaceControl KeyPad
1. Following the hub manual recommendations, install the .
Create an account, add the hub to the application, and create at least one
room.
Ajax application
2. Switch on the hub and check the internet connection (via Ethernet cable
and/or GSM network).
3. Ensure that the Hub is disarmed and does notupdateby checking its status
in the mobile application.