Instruction manual

KONA 3 Installation and Operation Manual — Using The KONA 3 Control

2K Crop Tab

Screen

This Tabbed screen allows you to determine how 2K frames captured with VTR

Exchange and brought into Final Cut will be cropped. You can select a crop mode and

then pan and scan around to choose the area that will be displayed. This can be done

dynamically with a mouse or by entering explicit numbers

KONA 3 Control Panel, 2K Crop Tab, Showing a 2K Crop to 1080PsF from Film Raster

Select a crop mode by choosing 1920 x 1080 or 2048 x 1080 from the pulldown

menu; choosing “Off” turns off 2K frame cropping.

In the Format Tab window, this corresponds to:

Select crop mode

Explicitly specify

an X and/or Y Offset

for the crop

via pulldown

Select a crop area

by moving the rectangle

using these navigation

buttons (arrows).

Square button at center

is used to re-center the crop.

Moving the mouse

cursor while holding

the mouse button

down moves the

crop rectangle within

the 2K frame

One way to move

the crop area:

Two other ways to move the

crop area: