Instruction manual

1
57
KONA 3 Installation and Operation Manual — Using The KONA 3 Control
KONA 3 Control Panel, Test Pattern Choices
Hold Last Application: this selection directs KONA 3 to hold and output the last
frame of video from the last application to control KONA 3. This can be helpful
when operating in an environment where you're switching back and forth
between multiple application windows.
Tip:
pressing and holding the Apple COMMAND key while clicking in the KONA
Control panel—while in any software application (Final Cut, etc.)—causes control of
the KONA card to stay with that application, rather than shifting to the Control Panel.
This works regardless of the setting of “Default Kona Output.”
Genlock (Freerun, Ref In, Input 1, or Input 2)—selects how KONA 3 will synchronize
program video:
Freerun: In this mode, KONA 3 generates sync without an external reference
source
Ref In: Directs KONA 3 to use the Ref Video source for sync (usually an analog
black burst video signal)
Video: Directs KONA 3 to use whichever video input source has been selected in
the Inputs tab window for sync
Timing (Horiz and Vert)—these two pull-downs allow output timing adjustment
with reference to the Ref Video source selected. The Horizontal reference can be
adjusted by selecting a number of pixels (clocks) to offset. Vertical can be adjusted
by specifying a number of lines to offset.