Instruction manual

1
43
KONA 3 Installation and Operation Manual — Using The KONA 3 Control
Tabs available are:
Inputs: view and edit input selections and how they are mapped.
Formats: select the framebuffer primary video format, any secondary.
formats, and parameters of up/down/crossconversion for input/output.
Digital Out: assign outputs either Primary or Secondary formats.
Analog Out: configure the component/composite +Y/C analog output.
Control: configures KONA 3 default output (test pattern, pass through, desktop,
etc.) plus setting genlock and output timing.
DS Keyer: configure the hardware-based downstream keyer for putting image files.
with alpha channels, like logos, or other video material with an alpha channel.
on top of video being passed through the card or played out of the card.
Setup: configures Video and Audio options such as composite black level and
analog audio monitor level.
Codec: used to select codec options such as whether paused video appears as a full
frame or a single field (jitter shown or not shown) and 24 to 30 fps padding
patterns.
Timecode: monitor RP-188 timecode and configure timecode window burn
output
2K Crop: select a 2K crop mode and the portion displayed from the overall frame.
Info: displays status information about the KONA 3 card and how it is installed in
the host Macintosh. This information is generally intended for
troubleshooting and support.
Input Tab Screen
KONA 3 Control Panel, Inputs Tab
Click a Tab to
Select a Screen
Click to Select
an Input