Instruction manual

1
37
KONA 3 Installation and Operation Manual — Genlock and Your System
13. A system prompt will pop up with a reminder that OS X must be restarted
after installation. Click the Continue Installation button to proceed.
14. The installer will run and put all the necessary KONA 3 drivers, KONA 3
Control Panel, presets and additional software on the desired hard drive. When
it has completed installation, a final screen will be displayed announcing that
“software was successfully installed.”
15. Click the Restart button to complete the installation procedure. The system
will perform a software restart and be ready for use.
Final Installation Screen
Genlock and Your System
For video stability and proper system operation, it’s always best to genlock all
equipment to house sync. Although genlock is not absolutely required for KONA 3 or
your system, better quality and repeatable operation will be experienced by doing so.
Usually, this means using a black burst generator output looped through the system.
On the KONA 3 cables and optional K3-Box breakout box, house sync is connected
to “Ref Loop”.