Instruction manual

26
6. Cable the system audio and video sources, VTR, audio monitor, and video
monitor. If you purchased the optional Breakout Box, then install it into
an equipment rack or place it on a desk and connect its cables to the
KONA 3 card. If you're instead using the standard cable set, then use those
to connect equipment.
Each of these steps are explained in greater detail in the pages of this chapter.
Unpacking
Shipping Box
Contents
KONA 3 is shipped with a CD containing system software for
installation and a user manual (a PDF on the CD), and two cables
(a multi-pin to multi-connector breakout cable and a x4 BNC to
1.0/2.3 connectors cable). If you purchased the optional K3-Box
breakout box, it ships with a multi-pin to multi-pin cable for
connecting from the KONA 3 card to the breakout box. The x4
BNC cable to 1.0/2.3 connectors cable that shipped with the card is
also needed interconnect the SDI connectors out of the card to the
breakout box.