Instruction manual

1
59
KONA LS/LSe Installation and Operation Manual — Easy Setups for Typical Uses
The A/V Devices Window
Audio/Video Settings, A/V Devices Window
The A/V Devices window selects the current hardware playback device for both audio
and video. Typically, you’ll select KONA LS for both playback devices. The format
chosen determines the Primary format for the KONA LS board during playback. The
Video Options button is greyed out for KONA LS (use the KONA LS Control Panel
for video configuration; the Audio Options button opens a second dialog where Final
Cut gives options for changing bit depth, number of channels, and the sample rate.
Since Final Cut currently only supports 2 channels of audio, AJA recommends you
leave all of these settings as set in the factory defaults.
You may wish to use a different KONA LS output for final Print-to-tape from Final
Cut. You can select that in this window by clicking the checkbox “Different Output
for Edit to Tape/Print to Video.” This allows you to select via a pull-down menu any
KONA LS video output and audio output.
The window also allows you to turn on and off device and audio output warnings.