Instruction manual

38
Tabbed Windows—The bottom area of the KONA LS Control Panel provides
different information categorized by topic. Clicking on a “Tab”—or a block
diagram element—will result in an information screen corresponding to a
tabbed topic. The arrows at either side of the displayed tabs can be clicked to
see any additional tabs not visible on the screen. If an arrow is “grayed out”,
then it means there are no additional tabs in that direction. Each of these
tabbed windows are described on the following pages. Tabs that can be
selected are:
Inputs: view and edit input selections and how they are mapped
Proc Amp: view and edit the analog proc amplifier settings (brightness,
contrast, hue, and saturation)
Formats: select the framebuffer primary video format for inputs/outputs
Analog Out: configure the component/composite analog output
Control: configures KONA LS operation (pass through, desktop, etc.) plus
sets output timing.
Setup: configures Video and Audio options such as composite black level and
analog audio monitor level.
Codec: used to select codec options such as whether a pause stops on a full
frame or a single field (jitter shown or not) and 24 to 30 fps padding patterns.
Timecode: monitor and configure RP-188 (SDI embedded) timecode
Info: displays status information about the KONA LS card and how it is
installed in the host Macintosh. This information is generally intended
for troubleshooting/support.
Input Screen
KONA LS Control Panel, Inputs Tab
Click a Tab to
Select a Screen
Click to Select
an Input