Instruction manual

1
27
KONA LS/LSe Installation and Operation Manual — Cabling the System
KONA LS System Cabling When Using The Breakout Cable
KONA LS System Using the Breakout Cable
Typical System
A figure on the following page shows typical system interconnections for a system
with digital A/V sources. Your system may differ depending on VTRs, audio
monitoring, and video monitoring.
1. If desired, connect your house reference sync to the KONA LS Ref Loop
connector (BNC). The second KONA LS Ref Loop connector on the KL-box
(if used) can be connected to your VTR or terminated with a 75 ohm
terminator.
2. Connect a Video Monitor to the KONA LS Component Analog Video Out
BNC connectors (preferred), or instead connect to a composite monitor.
3. Connect a 9-pin DB9 machine control cable between your VTR’s RS422
control port and the KONA LS RS-422 machine control connector. (On the
6 BNCs (Analog Connections):
Can be Configured for
Component,
Composite,
or Y/C
Standard Breakout Cable
KONA LS
Installs in
PCI Slot
G4 or G5
Reference Input BNC
RS422
Machine Control
to VTR
(user-supplied 9-pin cable)
SDI Input BNC
SDI Output 1 BNC
SDI Output 2 BNC
Y/CVBS In BNC
Pb/Y In BNC
Pr/C In BNC
Y/G/CVBS Out BNC
Pb/B/Y Out BNC
Pr/R/C Out BNC
green
blue
red
green
blue
red
Analog Audio
Channel 1 Input
Analog Audio
Channel 2 Input
Analog Audio
Channel 1 Output
Analog Audio
Channel 2 Output
AES Input
Channels 1 & 2
AES Output
Channels 1 & 2
44-pin connector
To KONA LS
Balanced Audio