Instruction manual

1
25
KONA LS/LSe Installation and Operation Manual — Cabling the System
Insert the KONA LS Into the Slot
Note: After you install the KONA LS card, you may notice that in the MacOSX
Network preferences there is a message stating “You have a new network port
named KONA LS —be sure to check the settings...”. There is no need to take any
action; this occurs because MacOSX detects the RS-422 serial port on the KONA
LS card that you will use for VTR machine control.
Cabling the System
System Video/
Audio Cable
Connections
When installing your system, you’ll make video and audio input/output connections.
These connectors are explained individually in chapter 2. Here, system
interconnection is shown and described.