Instruction manual

62
Using 4K Mode
In 4K Mode, you can input (for capture) or output four channels of video representing
individual quadrants of the higher definition 3840x2160 and 4096x2160 4K formats, see
“Format Screen in 4K Mode” on page 65.
Note: The KONA 3G can only be configured for either input or output of 4K at a time. It
cannot support 4K input and output at the same time since both require four BNCs.
Physical connections of the quadrants will be mapped to the KONA 3G SDI connectors as
shown in the following screens. For the HDMI and Analog Outputs, you can select just one of
the quadrants for viewing (see their respective tabs for quadrant selection).
Mapping of Quad SDI Outputs
This section describes the AJA Control Panel operations specific to 4K Mode. Note that in 4K
Mode, you can still capture and playback SD, HD, and 2K formats, though there are no up/
down/cross conversions available. You will see SDI inputs only when SD, HD, or 2K inputs are
selected. SDI Outputs 1 & 2 will be reconfigured as SDI 1 & 2 Inputs on the screen.
.
HD SDI Inputs in 4K Mode
Note: Up, Down, and Cross Conversion are available only when the KONA 3G module has
Standard Mode firmware installed (see “Firmware Screen” on page 62).