Cautions To ensure the safety of the equipment and personnel and the accuracy, the following items should be observed. @ Precise device, please handle with care. @ High temperature, non-professionals do not operate at will. & High precision sensor Do not pull or press. @ Do not touch the surface beyond the measure point with soldering tips in high temperature Alcohol can be used to clean up any flux attached to the point. Do not use dilute or volatile oil.
Product Features DITTO smart digital display thermometer includes the following features @ Simple and fashionable appearance, easy and convenient for use. @ LODE HD display, smart and digital, clear and intuitive. Thermonuclear and K-type socket design, enables to measure the temperature of soldering tips, hot air gun, surface, liquid, etc. Precise measurement,accurate, stable and efficient, built-in temperature curve record and replay.
List of Packing The package of DDT includes the following components fig i L K-type Triangle thermonuclear somatosensory | Go Type-Explicable 3
Parameters Modesto Dimension: Working Components: Triangle temp thermonuclear Temp range :0-500°C DPI:1°C Accuracy: £3°C Displeasure Battery: 9V alkaline dry cell Display LODE HD digital display Max key °C/F key Click to switch Click: switch “Can °F temp/HOLD Long press: ON/OFF Bluetooth Pull rod ball Pull down when replacing temp sensor Temp sensor Replaceable temp sensor 04
ON/OFF key Click: ON/OFF the device Long press: forcibly enable the USB mode Type-C socket Type-C USE cable port Removable battery slot K-type socket on the right side Standard package with a thermonuclear ® falcons Use BT on BT connected BT off Charge 0s
Operating steps Operation steps of DITTO @ Ste pl Fut the red side of sensors in the red end, the blue side in the blue end, and the silver side In the above end. @ Step Click the power switch start operating when the temperature shows on the screen ® Step Click the *C/F key to switch *C and °F. *Uls generally used. @ Step Before testing, add some tin on the soldering Iron tip, the soldering tip should be 45 * from the test point.
Step 5 When the temperature is stable, press the "MAX HOLD kay and it will display at the lower right of the window. At this time, the thermometer will keep the current maximum temperature tested and record the data, Press "MAX HOLD" again to start a new measurement. Step 6 After use, clean the residue, press the power switch to shut down the device, and finish the measurement.
