Service manual

– 97 –
Various settings can be returned to the default mode when shipped from the factory by performing the
following procedure.
1) Turn ON the main power and enter the DVD mode.
2) Eject all discs to establish the NO DISC state and wait until the DISC READING is completed.
3) Keep pressing the DISC button and the BACK SKIP buttons at the same time until the aiwa wall paper disappears on the
display. When the aiwa wall paper disappears, remove the hands pressing the buttons. (It takes about 4 to 5 seconds.)
4) The aiwa wall paper appears again and the message "AL CLEAR" appears on the FL display.
5) Turn OFF the main power. This is the end of the procedure.
ON THE DEFAULT MODE WHEN SHIPPED FROM THE FACTORY