Service manual

– 9 –
Anode Button
Assembling position
2-2. Anode cap assembly
Make sure to keep the notices not to make troubles when
assembling or disassembling the Anode Cap.
2-2-1. Notice Before Assembly
Strictly forbidden to rotate Anode
Cap after assembling.
Do not use a deformed hook.
1) If the Anode Cap is rotated after assembling, the Anode
Cap may slip off. Route the high voltage cable before
fixing the Anode Cap (See Fig-7).
2) If the Anode Cap is fixed before routing the high voltage
cable by mistake, route the cable without rotating the
Anode Cap at all.
2-2-2. Anode Cap Assembly
1) Wipe the assembling position with a clean cloth
moistened with a little alcohol (See Fig-8).
Note) Confirm that there is no dirt, dust, etc in the
assembling position.
2) Apply a proper quantity of the designated silicon grease
(use KS-650N) in the direction of circumference
(See Fig-8).
Note) Take care that the silicon grease dose not get
into the Anode button.
3) Straighten the high voltage cable and arrange the wire
not to twist (See Fig-9).
Note) If the wire is not correctly arranged, the Anode Cap
rotates and it causes a failure.
Anode Cap
Left
Right
High Voltage Lead Wire
Anode Cap
Fig-7
Fig-8
Fig-9