Service manual

– 22 –
WIRE PROCESSING (WIRING, TYING) METHOD
* Be sure to follow the instructions described as follows when processing the wires during disassembling and reassembling, in order
to secure safety upon completion of the repair work.
* The parts that are shown with the
SAFETY
mark in the illustrations, are the parts that are specifically designed as the safety related
important parts by the safety regulations. Pay utmost care for these marks.
* For tying the wires, the following parts are mainly used.
Note) Be sure to follow the instructions described as follows when processing the wires during disassembling and reassembling, in
order to secure safety upon completion of the repair work.
1. Routing of the wires on top of the MAIN board.
Soldered to P.Cs.
Fixed by Screws.
Cannot be re-used.
Coating lead pin
Wire binder
Cable,tie
A
Outside appearanceName
Number in
illustrations
B
C
SAFETY
SAFETY
HT602
R629
(RED WIRE)
Must not touch to SH1
and IC804.
(BROWN WIRE)
Must not touch to
HT602, R629 and
R626.
SH1
IC804
PWB, MAIN
R626
WIRING ARRANGEMENT