Service manual

– 10 –

4) Turn over the edge of the Anode Cap as the left figure

(See Fig-10).

Note) The right and left sides of the Anode Cap should be

turned over equally.

Note) Take enough care not to scratch the Anobe Cap.

5) Hold the Anode Cap with the thumb and middle fingers

while supporting the middle projection with the forefinger

as the left figure. (See Fig-11-1)

6) Insert the one side of the hook to the anode button. (See

Fig-11-2)

Note) Confirm that the hook is surely hitched.

7) Hook the claw at the other end of the shutter hook on the

anode button as Fig-11-3.

Note) Hook the claw at the other end in the manner of sliding into the Anode Button as shown.

Note) When the shutter hook is inserted into the Anode Button completely, the clicking sound can be heard.

Fig-10

Fig-11-1

Anode Button

Shutter Hook

Anode Button

Shutter Hook

Anode Button

30°

Fig-11-2

Fig-11-3