Datasheet

ENGLISH 9
TIMER OPERATION
D
Timer playback/Alarm
You can turn on the player at a specified time every
day with the built-in timer, and you can also use the
player as an alarm clock.
Make sure the clock is set correctly.
1
Press OPERATE to turn on the player.
2
Select the function, CD, RADIO or TAPE.
CD or RADIO: The selected source starts
playback at a specified time.
TAPE: The player can be used as an alarm clock.
Beep sound rings at a specified time.
3
Hold down ALARM/TIMER until the hour
flashes.
Timer Alarm
4
Press r or t to specify the hour of
the timer/alarm-on time, and press
ALARM/TIMER.
The hour stops flashing and the minute starts
flashing.
5
Press r or t to specify the minute
of the timer/alarm-on time, and press
ALARM/TIMER.
6
Prepare the source for the timer.
RADIO: Select the band and tune in the desired
station.
CD: Load the CD.
7
Turn off the player after adjusting the
volume.
The symbol mark remains lit on the display to
indicate the player is in timer/alarm standby
mode.
Note
Do not try timer playback of the tape and timer
recording. Doing so causes malfunction for the player or
damage to the tape.
Tips
• The alarm volume cannot be adjusted.
• The alarm beeps for about 5 minutes and stops.
•When using the player after setting the timer/alarm,
repeat steps 2, 6 and 7.
•You can change the mode, to timer or to alarm, after
completing all the steps. Repeat steps 1, 2, 6 and 7.
When changing the mode while the power is off, you
cannot check it on the display.
To check the timer/alarm-on time
Press ALARM/TIMER while the power is on.
The time is displayed for 4 seconds.
To cancel the timer/alarm standby mode
Press ALARM/TIMER repeatedly until the symbol mark
( or
5
) disappears.
To restore the standby mode, press it again.
To stop alarm sound
Press ALARM/TIMER or OPERATE.
To reset the timer/alarm
Repeat all the steps again.