INSTRUCTION MANUAL X AIR 65 www.aivituvin.
NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals. Be aware that some parts are heavy and have sharp edges. Be aware that moving parts can injure,crush and cut.
TOOLS REQUIRED PHILLIPS SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 45MIN. ASSEMBLY HARDWARE M3.5x45mm SCREW 24PCS+1spare M3.5x60mm SCREW 10PCS+1spare P1 P2 M3.5x25mm SCREW 4PCS+1spare M3.5x35mm SCREW 8PCS+1spare P3 P4 M3.5x40mm SCREW 8PCS+1spare M3.
PARTS Back Panel Front Panel- Down 1PC Front Panel- Upper 1PC A Left Side Panel 1PC 1PC B C Tray-Upper 1PC Right Side Panel 1PC F E D Tray-Down Wire Pen Ramp Support 1PC 3PCS 1PC G 03 H I
PARTS Side Wire Pen Ramp 1PC Wire Pen-Right Back 1PC 2PCS J Roof of Pen K Tray of Pen 2PCS 2PCS L Roof of Hutch 2PCS M O N Back casters with brakes Front casters without brakes Roof Cap 1PC 4PCS P 4PCS Q R Back Panel-Down 1PC S 04
PRODUCT ASSEMBLY 01 Attach the panel part A,B,C,D,E,S by 16XP2 screws. C E A P2 X 16 S B D 02 Attach the casters without brakes 2Xpart R in front and the casters with brakes 2Xpart Q in back.
PRODUCT ASSEMBLY 03 ① Slide in the tray part F & G. ② Attach the wire pen part H to the left side of hutch by 4XP1 screws. P1 X4 H F G H 04 ① Attach the wire pen part H & J to the right side of hutch by 4XP1 screws.(Please pay attention the position of part J) ② Attach the ramp support part I to the part J by 2XP1 screws.
PRODUCT ASSEMBLY 05 Screw the ramp part K to the right side panel by 4XP5 screws. P5 X4 K 06 Attach the 2Xpart R to the front of part L. Attach the 2Xpart Q to the back of part L.
PRODUCT ASSEMBLY 07 Attach the side wire pen part L by 4XP2 screws each side. L P2 X4 P2 X4 L 08 M Attach the roof of pen part M by 4XP6 screws each side.
PRODUCT ASSEMBLY 09 Slide in the tray part N. N 10 Attach the roof of hutch part O by 8XP3 screws.
PRODUCT ASSEMBLY 11 Attach the roof cap part P by 4XP4 screws. P4 X4 P 12 Attach top panel of pen and side panel with 1XP7 by 4XP5 each side.
WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
