INSTRUCTION MANUAL AIR 62 www.aivituvin.
NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals. Be aware that some parts are heavy and have sharp edges. Be aware that moving parts can injure,crush and cut.
TOOLS REQUIRED PHILLIPS SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 45MIN. ASSEMBLY HARDWARE M3.5x25mm SCREW 28PCS+1 spare M3.5x40mm SCREW 16PCS+1 spare P1 M3.0x16mm SCREW 12PCS+1spare P2 Lock 2PCS P3 Bowl 1PC P4 Chewing toy 1PC P5 P6 Connector 2PCS P7 （Only for 2 cages combination.
PARTS Panel of hideout 1PC Panel of hideout Panel of hideout 2PCS 1PC A Roof of hideout 1PC B Front panel-up 1PC Back panel 1PC D C F E Front panel-down Left panel Right panel 1PC 1PC 1PC G 03 H I
PARTS Casters with brake Casters without brake Layer 2PCS 2PCS 1PC J K L Tray Small layer Ramp 1PC 1PC 1PC M N O Roof 1PC P 04
PRODUCT ASSEMBLY 01 Attach the hideout Part A, Part BX2, Part C, Part D by 12xP2. C B 02 B D A P2 X12 Attach the front Part F, G & back Part E to left Part H & right Part I by P1X12.
PRODUCT ASSEMBLY 03 ① Screw the caster Part J to the back of cage by 4XP2 each side. ② Screw the caster Part K to the front of cage by 4XP2 each side. Jx2 P2 X4 04 Kx2 P2 X4 Put layer Part L in lower position of the cage.
PRODUCT ASSEMBLY 05 ① Slide in the tray Part M. ② Put the small layer Part N into the cage, hang the ramp Part O on Part N. O N M 06 Put the bowl Part P5, chewing toy Part P6 and the hideout into the cage.
PRODUCT ASSEMBLY 07 Screw the roof Part P by 4XP1. P P1 X4 08 Screw the lock Part P4X1 by P3X4 each side.
Notice Read Before Assemble! For 2 cages combination. ①Take out the right middle panel from cage 1. ②Take out the left middle panel from cage 2. CAGE 1 09 CAGE 2 Put the hideout, the small layer Part N, the ramp Part O into the cage.
PRODUCT ASSEMBLY 10 Screw the Connector 2xP7 to the middle frame of the 2 cages by 4xP3 each side.
WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
