INSTRUCTION MANUAL AIR 57 www.aivituvin.
NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals. Be aware that some parts are heavy and have sharp edges. Be aware that moving parts can injure,crush and cut.
TOOLS REQUIRED PHILLIPS SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 45MIN. ASSEMBLY HARDWARE M3.5x40mm SCREW 16PCS+1 spare M3.5x50mm SCREW 2PCS+1 spare P1 M3.5x25mm SCREW 28PCS+1 spare P2 M3.
PARTS Front Panel of Small House 1PC Side Panel of Small House 2PCS A Back Panel of Small House Roof of Small House 1PC 1PC B C D Front Panel- Down Back Panel- Down Left Side Panel Right Side Panel 1PC 1PC 1PC 1PC H G F E Front Panel- Upper Back Panel- Upper Side Panel Back Casters with brake 1PC 1PC 1PC 2PCS I 03 J K L
PARTS Front Casters without brake Bottom Floor Tray Layer 2PCS 1PC 1PC 1PC M N O P Bottom Ramp Middle Floor Divider Panel Middle Ramp 1PCS 1PC 1PC 1PC Q R S T Roof 2PCS U 04
PRODUCT ASSEMBLY 01 Attach the small house,attach part A,B,C,D by 12XP3 screws. C B D B 02 A P3 X12 Attach the part E,F,G,H by 8XP2 screws.
PRODUCT ASSEMBLY 03 Attach the part J,K,I by 8XP2 screws. J P2 X4 K P2 X4 04 I ① Attach the upper and down parts by 2XP1 screws. ② Screw the casters with brake part L in back by 8XP3 screws. ③ Screw the casters without brake part M in front by 8XP3 screws.
PRODUCT ASSEMBLY 05 Slide in the bottom floor part N. N 06 ① Slide in the tray part O. ② Put the part P inside the cage as show on the picture. ③ Hang on the ramp part Q to part P as show on the picture.
PRODUCT ASSEMBLY 07 ① Put the part R inside the cage as show on the picture. ② Screw the ramp part T to the part R by 2XP4 screws as show on the picture. ③ Put the part S inside the cage as show on the picture.
PRODUCT ASSEMBLY 08 Put the small house,P7,P6 inside the cage anywhere you want.
PRODUCT ASSEMBLY 10 Screw the latch 4XP5 to the roof and tray by 16XP4 screws.
WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
