INSTRUCTION MANUAL AIR 15 www.aivituvin.
NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals. Be aware that some parts are heavy and have sharp edges. Be aware that moving parts can injure,crush and cut.
TOOLS REQUIRED PHILLIPS SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 45MIN. ASSEMBLY HARDWARE M3.5x35mm SCREW 8PCS+1spare M4.0x45mm SCREW 18PCS+1spare P1 P2 M3.0x16mm SCREW 2PCS+1spare M3.5x25mm SCREW 20PCS+1spare P3 P4 Chewing toy 1PC M3.
03
PARTS Back panel - Up Front panel - Down 1PC Front panel - Upper 1PC A Back panel - Down 1PC 1PC B Left panel 1PC D Middle plastic tray 1PC Right panel 1PC E Divider 1PC G C F Bottom wire netting 2PCS H I 04
PARTS 1PC J Roof cap 1PC 2PCS K Casters without brake 2PCS M Folding metal feeder 1PC P 05 Asphalt roof x2 Bottom plastic tray 1PC Ramp N Ramp Supporting board 1PC Q L Brake casters 2PCS O
PRODUCT ASSEMBLY 01 Attach the back panels up Part C, down Part D to the left side panel Part E and right side Part F by 4xP1 screws each side. E C F P1 X 4 02 P1 X 4 D Attach the down panel Part B by 2xP1 screws each side.
PRODUCT ASSEMBLY 03 Put inside the wire bottom floor Part I to be UPWARDS in order to seperate the urine & poop. Ix2 04 Screw the ramp supporting board Part Q to the Part D by 2xP2 screws.
PRODUCT ASSEMBLY 05 Screw the ramp Part J to the bar of Part E by 2xP4 screws. J P4 X2 06 Attach Part A by 2xP1 screws each side.
PRODUCT ASSEMBLY 07 Slide in the middle tray Part G and bottom tray Part K. G K 08 Screw the metal feeder Part P to the Part F by 2xP5 screws.
PRODUCT ASSEMBLY 09 Slide in the divider Part H. 10 Screw two casters without brake Part N to the front of hutch legs by P3x8 screws.
PRODUCT ASSEMBLY 11 Screw two brake casters Part O to the back of hutch legs by P3X8 screws. Ox2 P3 X8 12 ① Screw the 2 roof Part L to the top by 8xP2. ② Notice to level up the roof.
PRODUCT ASSEMBLY 13 Screw the roof cap Part M by 4xP3 screws.
WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
