INSTRUCTION MANUAL X AIR 12-IN
NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals. Be aware that some parts are heavy and have sharp edges. Be aware that moving parts can injure,crush and cut.
TOOLS REQUIRED PHILLIPS SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 30MIN. ASSEMBLY HARDWARE M3.5x40m SCREW 8PCS+1spare M3.5x45mm SCREW 2PCS+1spare P1 P2 M3.0x16mm SCREW 8PCS+1spare M3.
PARTS Left panel Back panel 1PC Front panel 1PC A Right panel 1PC 1PC B Bottom floor Bottom floor 1PC D C 1PC F E Eaves Curtain Roof 1PC 1PC 1PC G 03 H I
PARTS House insulated liner 1PC J Roof insulated liner 1PC K 04
PRODUCT ASSEMBLY 01 Attach the curtain part H to front panel part A by 2xP3 screws. P3 X 2 H A 02 Attach the Eaves part G above the door by 2xP1 screws.
PRODUCT ASSEMBLY 03 Attach the back panel part B to side panel part C & D by 4xP2 screws. C D 04 B P2 X4 Attach the front panel part A to the hutch by 4xP2 screws.
PRODUCT ASSEMBLY 05 Attach the foot pad 4XP6 to each legs . P6 X4 06 Put the bottom floor part E & F inside the hutch as show on the pictures.
PRODUCT ASSEMBLY 07 ① Put the insulated liner Part J in the house first. ② And then finally put in the bottom liner.
PRODUCT ASSEMBLY 08 Attach the roof panel part I to the hutch by 4xP4 screws. I P4 X4 09 Screw the roof hinge P5 to connect the roof and side panel by 4xP4 screws.
PRODUCT ASSEMBLY 10 Stick the roof insulated liner Part K to the INSIDE roof.
WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
