User manual

- 5 -

Replacing the antenna

1. Loosen the interior trim in the roof at the installation location. In order to loosen the “headliner”, ﬁ rst

the side panel (C column), depending on the type of vehicle, must be removed.

2. Separate the screw or plug connection of the antenna cable and loosen the fastening nut of the

antenna to be removed.

3. Remove the antenna with base from the outside.

4. Important: If a square antenna hole is available, then push the supplied square rubber adapter piece

(Var. I) over the threaded axle of the antenna prior to installation. For a round hole, use the round

rubber ring (Var. II).

5. Hang the seal support (c) on the existing nose of the antenna base (b). Carefully put the edge of the

sealing support ring (c) over the antenna base (b).

6. Insert the antenna base (b) with sealing support ring (c) and antenna cable (e) with power cable (f)

into the antenna hole from the outside.

7. Pull the hexagon nut with sprocket (g) over the antenna cable (e) and lightly secure to the antenna

base (b).

8. If the sealing support ring (c) and antenna base (b) are sitting properly, the hexagon nut with

sprocket (e) can be tightened with a 22 mm, 7 nM wrench.

9. Connect the antenna cable (e) and power cable (f) of the antenna with the existing cable in the roof.

10. Verify radio reception.

11. Replace the paneling again.