User's Manual

Installation

ALEVEL 1F5 . User Manual

4 Installation

The casing of ALEVEL 1F5 is sealed and non-openable. The device is equipped with non-replaceable

battery. If the battery of the device is discharged it should be replaced with new ALEVEL 1F5.

4.1 Installation on-site

The installation process is easy, intuitive and only requires replacing the

“remote ready” plug by inserting ALEVEL 1F5. If there is no dial installed in the

gauge socket , simply place it first with two original bolts.

4.2 ALEVEL 1F5 activation

For safe transport and in order to minimize the battery consumption during the storage (prior the

installation), the device is in sleep mode directly after the production. To wake ALEVEL 1F5 up a

dedicated tool

is required.

5 FCC PART 15 COMPLIANCE

Modification statement

AIUT Sp. z o.o. [Ltd.] has not approved any changes or modifications to this device by the user. Any

changes or modifications could void the user’s authority to operate the equipment.

Interference statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Wireless notice

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and

meets the FCC radio frequency (RF) Exposure Guidelines. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

If the activating procedure is performed in potentially explosive area it must be performed with the tool

certified for use in hazardous areas. Otherwise, the procedure must be performed beyond the area.