User's Manual

8
080-00001-00 AITEK USER MANUAL
Proprietary of Aitek Inc
7.2.2 Set up distribution network – Using WiFi, Ethernet or Bluetooth
Open the Helium App from your phone, register to enter and select "Set up
Hotspot".
Select Aitek Miner Plus, read the “network configuration instructions” if you
haven’t read it, or bypass the “network configuration instructions” by select "Skip"
to follow the on-boarding step by step prompts on the app.
Once ready, power up the gateway by plugging in the power adapter AC end to
an AC power outlet and plug the DC end to the DC 12V socket on the device.
After plugging in the power, the LED of the gateway turns red and then yellow.
Below steps showing three methods of pairing the Aitek’s Miner Plus hotspot.
Please note, only one of the three method is needed to pair up the device.
1. WiFi pairing:
If you use WiFi pairing technique, select the WiFi from the app, select the name
of the WiFi router you are networking with. Enter the network password and
press “next”. Follow the app’s step by step process. Once on-boarding is
successful, the LED light will turn green.
2. Bluetooth pairing:
Insert a pin into the BT BUTTON hole and press the button for 2 seconds, then
watch the LED turn blue to start Scan. After scanning the device, click to enter
the next step. Follow the app’s step by step process.
At this step, the network pairing is completed, LED color will change from blue to
green.
Device Power
Input