ASSEMBLY INTRUSION FULL BED IMPORTANT NOTE 1. PLACE ALL PARTS ON A CLEAN AND SMOOTH SURFACE SUCH AS A RUG OR CARPET TO AVOID THE PARTS FROM BEING SCRATCHED 2. BEFORE YOU BEGIN, KINGLY FOLLOW THE ASSEMBLY INSTRUCTIONS STEP BY STEP 3.
Part list BOX 1: WF288468 Leg bed (2 pc) Leg bed (2 pc) Leg bed (2 pc) Leg bed rail (2 pc) bed rails (1 pcs) Headboard rails (1 pcs) | Bed support bar (2 pcs) Bed slats 8 pcs Bedside support bar 2 pes Bedside support bar 2-cps | Learning support bar 2 pcs =~ Front Drawer 2 pcs V2 < Sid brood Drawer box 4 pes V3 > bottom panel 2 pcs V6 AN Back boar Drawer box 2 pcs Page 2
Hardware list in WF288468 0 1/4" x 90 mm Hex head bolts 6 pcs 2 1/4" x 25 mm Hex head bolts 16 pcs 3 1/4" x 65 mm Hex head bolts 8 pcs 4 & 1/4" x 15 mm Horizontal-hole bolt 14 pcs Wood dowel 4 pcs 6 Om m4 x25 Wood screws 44 pcs 7 Bo m3.
STEP 1/4" x 80 mm Horizontal-hole bolt -2 pest Hex head bolts 2 pos Note: Part 4 will face up with the "x" mark on it, otherwise it cannot be tightened RS 28x30 Wood dowel 4 pos STEP Hex head bolts 12 pcs 1/4" x 26 mm Page 4
Note: Part 4 will face up with the "x" mark on it, otherwise it cannot be tightened 1/4" x 15 mm 1/4" x 80 mm Horizontal-hole bolt pos | Hex head bolts 4 pes STEP Page 5
Note: Part 4 will face up with the "x" mark x85 mm 147x 25 mm otherwise it cannot be tightened Horizontal-hole obit -8 pest Hex head bats -8 pcs | Hex head bolts 4 pos STEP Note: Do not lock the screws of the trundle slats to te outermost edge the trundle slats, you need to leave a certain space at the edges, otherwise it will cause the board to break 12 m4 x25 Wood screws 24 pes Page 6
