User's Manual

KDC User Manual BLUETOOTH





Discovering

KDC200/250/300/270/350 starts to search for neighboring Bluetooth devices if the Discovering menu

is executed. It will take about 30 seconds to finish searching and to list available neighboring

Bluetooth devices. Another option is to enter the corresponding Bluetooth MAC address in the

KTSync Bluetooth menu, instead of waiting for the KDC to search for neighborhood Bluetooth devices.

KDC20/30/400 only supports via KTSync configuration. KDC500 doesn’t support this feature.

Connect To

This option lets you easily connect the KDC to Bluetooth devices that have been either previously

registered in KTSync under the File Menu or discovered/connected from the KDC Bluetooth Service

menu. KDC20/30/400 only supports via KTSync configuration. KDC500 doesn’t support this feature.

There could be an interoperability issue depending on the corresponding device

Bluetooth stack. The master Bluetooth device may request that you to follow the

master Bluetooth device’s security procedures, if the KDC tries to connect to the master

Bluetooth device.

HID Sync

The user may synchronize stored barcode data over HID using the HID Sync option. The KDC will start

to transmit all stored barcode data upon execution of the HID Sync option. KDC500 doesn’t support

this feature.

Tips

Pair and connect KDC20i/30i/200i/250i/300i/270i/350i/400i and iOS4.0+ in HID iOS mode

x Users have to disable the MFi option in System > MFi menu and change the Bluetooth

profile to HID-iOS to use HID Bluetooth profiles.

x Users have to RESET the iPhone/iPad/iPod touch in order to change HID to MFi mode,

and vice versa, after removing a previous KDC connection.

x KDC with Bluetooth Spec2.1+EDR does not prompt Pin code entry menu.

x KDC with Bluetooth Spec. 2.1+EDR stack does not require 4 or 6 digits PIN digits entry

Follow the below steps in order to pair and connect KDC models for MFi and iOS4.0+ in HID

mode.

1. Go to the MFi menu of KDC SystemConfig Menu

2. Change MFi option to Disabled

3. Change ConnectDevice to HID iOS mode

4. Remove previous KDC connection and RESET the device

5. Change KDC to Pairing mode

0QVG