User's Manual

K
KDC User YOUR KDC


BT Service Menu – KDC20/30/200/250/300/270/350/400/500
Power
Users may choose to turn Bluetooth Power on or off. Select between Enable and Disable.
Pairing Mode
This option Enables user to enter pairing mode by simply selecting this menu.
z The KDC enters into pairing mode so that the host Bluetooth device may search for it.
z The KDC may exit pairing mode if the user presses the SCAN button or if it fails to pair with
the Bluetooth host device within 90 seconds.
Discovering
When users choose this menu, KDC searches for nearby Bluetooth devices. (KDC500 doesn’t support)
Connecting To
This option enables the user to inquire to a registered Bluetooth device. (KDC500 doesn’t support)
Disconnect
This option enables the user to disconnect KDC from the paired Bluetooth device. (KDC500 only)
HID Sync
KDC transmits all stored data to the host over HID profile if HID Sync option is enabled. (KDC500
doesn’t support)
Auto Pairing
Enables or Disable the automatic Host Bluetooth type detection (SPP or MFi).(i Model only)
GPS Config Menu – KDC250G/350G
Barcode and GPS data format
The GPS enabled model adds the GPS coordinate after the barcode data, if GPS data is available. The
GPS data starts with “<G|P/S]” and ends with “:”. For example, the GPS enabled model would
record barcode “1234567890” , GPS coordinate “4354.45275,N;07925.81993,W” and Altitude data
“208.7,M”as “1234567890<G|P/S]4354.45275,N;07925.81993,W ,208.7,M:” in the barcode data
field.
GPS Menu
z GPS Power: Turning GPS Power on or off
¾ Users may enable or disable the GPS Power.
¾ The GPS module consumes extensive battery power. To conserve battery power, it is
strongly recommended to turn off the GPS option when the GPS enabled model is not
being used for an extended period of time.
¾ It is also recommended to use the GPS Auto Power Off option in the SystemConfig
menu. This option automatically turns off the GPS power if a barcode is not scanned for