User's Manual

K
KDC User YOUR KDC
option.(1D Model only)
x USB cable insertion requirement is removed from FW2.85/86.O and FW 3.02.
x You may exit the auto trigger mode by pressing the scan button for 3 seconds.
Reread Delay
You may adjust the reread delay from continuous to extra-long.
Partial Display
This option enables the user to display partial data. You may define the start position and number of
characters to be displayed.
Data Process Menu
Wedge/Store
The KDC provides five modes of data transmission in keyboard wedging mode.
z Wedge Only: Barcode data is NOT stored in memory but transmitted to the host.
z Wedge & Store Only: Barcode data is stored in memory and transmitted to the host.
z Store Only: Barcode data is stored in memory but NOT transmitted to the host.
z Save if Sent: If data transmission is successful, barcode data is stored in memory.
z Save if Not Sent: If data transmission is NOT successful, barcode data is stored in memory.
Data Format
The KDC provides two data formats, Barcode Only and Packet Data.
z Barcode Only: The KDC transmits scanned barcodes only. You may incorporate appropriate
data transmission error detection and correction mechanisms in this mode. KDC supports a
selection of various termination characters for Barcode Only format. You may select
<NONE>, <CR>, <LF>, <CR+LF> or <TAB> as the termination character.
z Packet Data: KDC transmits packet data with checksum to minimize transmission errors.
KTSync sets Data Format to Packet Data format upon execution.
¾ You may change Data Format to Barcode Only if you would prefer to use the Barcode
Only mode. However, the KDC would stay in Packet Data mode if KTSync is aborted
abnormally. If this is the case, you may have to change the KDC back to Barcode Only
mode manually.
x Barcode Index: KDC20i/30i/200i/250i/300i/270i/350i/400i/500i add 4 bytes barcode
index to maintain last synchronized barcode information.
- This optional index would be added if data format is “Packet Data”.
0QVG
0QVG