User's Manual

K
KDC User YOUR KDC


2D S
ymbology
AztecCode
1(1)
3750(3750)
AztecRunes
CodablockF
1(1)
2048(2048)
Code16K
0(1)
160(160)
Code49
1(1)
81(81)
DataMatrix
1(1)
1500(1500)
MaxiCode
1(1)
150(150)
MicroPDF
1(1)
366(366)
PDF417
1(1)
2750(2750)
QRCode
1(1)
3500(3500)
HanXin Code
-
-
Postal Codes
Postnet
-
-
PlanetCode
-
-
UK Post
-
-
Mayada Post
-
-
Kix Post
-
-
Australia Post
-
-
Japan Post
-
-
China Post
2(4)
80(80)
Korea Post
2(4)
80(48)
OCR
OCR Off
-
-
OCR A
-
-
OCR B
-
-
OCR Passport
-
-
OCR MICR
-
-
OCR SEMI
-
-
Image Capture (KDC30/300/270C/350C/420/421/425/450/470C)
This option enables the user to capture an image in JPEG format in C:\myData folder. You should
enable the image capture option first, and then press the Scan button to start the aiming. A green
aiming light will illuminate and an image will be taken upon release of the Scan button. KDC will
disable the image capture option if the user presses the scan button for 5 seconds.
Security Level (Laser Model only)
This menu enables the user to ensure an accurate barcode reading by setting the number of times
the KDC will read a barcode. Security Level is set from 1 up to 4. The higher security level means
readings are more reliable; however, some performance degradation is likely. For poor quality
barcodes, we recommend increasing the security level. The default is 2.
Auto Trigger
Once enabled, Auto Trigger enables the user to scan a barcode automatically. You may adjust reread
delay from continuous to extra-long. Auto Trigger mode always enables the duplicate check
Table 4 - KDC30/300/350C/420/450/500C
Minimum Barcode Length