User's Manual

K
KDC User YOUR KDC

KDC Mode Menu
The KDC Mode Menu has two options – Normal Mode and Application Mode.
Normal
This is the default mode that provides basic barcode scanning. In normal mode, barcode data may be
manipulated directly through the KDC or through KTSync during the synchronization process.
Application
This mode enables the user to run the user application created by the Application Generation Tool,
as described in Chapter 6 Application Generation.
View Data Menu
This menu option enables the user to view and/or delete barcodes stored in the KDC. In the case of
the KDC20/30, you may delete the last scanned barcode by pressing the DELETE button on the right
side of the unit.
Set Barcodes Menu
This menu lists all the barcode symbologies supported by the KDC and enables the user to select the
barcode symbologies to be scanned. For maximum scan performance, you should select only the
symbologies that you will be scanning. Please refer to 10. Appendix A – 10.1 Symbologies for a
detailed listing of symbologies supported by the KDC.
Code Options Menu
The KDC supports various Code Options, including Transmission of Start and Stop Characters,
Symbology Conversion, Verification of Optional Check Character, and Transmission of Check Digit.
Please refer to 10. Appendix A – 10.2 Code Options for a detailed explanation of each option.
Scan Options Menu
Power(KDC500 only)
Users may choose to turn the Scan Engine Power on or off. Select between Enable and Disable.
Scan Angle (Opticon laser model only)
This option enables the user to configure the laser beam angle to the barcode. There are two
options for scan angle: Wide and Narrow. Wide is 54
o
and Narrow is 27
o
. The default is wide.
Press the DDelete button to delete the last
scanned barcode.
Figure 14 - Delete Function in KDC20/30