User's Manual

K
KDC User YOUR KDC


z
Modify the angle of the KDC in relation to the barcode, making the angle more wide or
narrow as needed. (Laser Model)
z
Modify the distance between the barcode and the KDC, moving closer or further away as
needed.
z
Check the option settings defined in the KDC menu section and change options as needed.
z
Check to see that the barcode’s width does not exceed the light beam’s width, and vice
versa.
Read Barcodes with GPS Coordinates (KDC250G/350G)
The KDC350G may add GPS coordinates after the barcode data. To do so, the user may follow the
below instructions.
Because of the characteristics of GPS, this function is only available when outdoors.
1. Go to GPS Power in GPS Menu and select Enable.
2. Check to see if the KDC is successfully acquiring GPS data by selecting Acquire Test in GPS
Menu.
When the user selects the Acquire Test, an ‘Acquiring’ message will appear on the screen. If
this is the first test, check to make sure the ‘Acquired’ message appears within 90 seconds
of acquiring GPS signal.
3. Go to SystemConfig in the KDC Menu and select GPS data in Display Format.
4. After finishing the configuration, scan a barcode as explained in 3.2.1 Reading Barcodes.
When the user has successfully scanned a barcode, the barcode data and GPS coordinate
will appear on the KDC screen.
For more information, refer to 3.3 Menu - GPS Config (KDC250G/350G).
Reading NFC Tags (KDC350N/400N/KDC500)
1. Enable the NFC Power option in the NFC Config menu.
2. Touch the NFC tag to the back of the KDC350N/400N case (or NFC logo on the front of the
KDC500 case), and make sure the tag and case are within 5cm of each other.
0QVG