User's Manual

KDC User Manual MULTIPLE SPECIAL BARCODES





17. Appendix G – Multiple Special

Barcodes

This chapter explains how to make a multiple configuration barcode for the KDC to configure multiple

KDC settings by scanning one barcode. The KDC provides special barcodes that enable changes to the

KDC configuration; but, this current barcode changes only one configuration. New KDC firmware

VersionR_305 introduces a feature to enable the user to make one special barcode to change multiple

KDC configurations.

17.1

KDC20/100/250/270L/350L/410/411/415/470L/500L

z Barcode type Code128 is used to make a single special barcode and its format is as follows:

Here, the <FNC3> is a Code 128 control character and the <Barcode String> is an ASCII string for each KDC

configuration.

z The multiple configuration Code128 barcode format is as follows and has a control character

and series of barcode strings.

Here, the <FNC3> is a Code 128 control character and the <Barcode String 1> and <Barcode String N> are an ASCII

string for each KDC configuration. The ‘;’ is a separator for each configuration’s barcode string. Please see user

manual for the <Barcode String> for KDC configuration.

z Example: Assume the user is changing the following configurations with one barcode.

¾ Change Wedge/Store to “Wedge Only” Î <FNC3>82000

¾ Change Termination Character to “None” Î <FNC3>88000

¾ Change Bluetooth “Auto PowerOff” to “Disabled” Î <FNC3>64010

<FNC3>82000;88000;64010

17.2

KDC30/270C/300/350C/420/421/425/450/470C/500C

z The following format is for a single configuration barcode format:

<SYN> M <CR> KDC <Barcode String>.