User's Manual

KDC350 User Manual

KTSync will synchronize barcode data from KDC in the burst mode if this option is enabled. Otherwise,

KTSync will synchronize barcode data one by one. This option is enabled by default and can’t be

disabled.

 Synchronization on connection

If this option is enabled, KTSync will automatically synchronize barcode data from the KDC when the

KDC is connected.

 Clear KDC memory after synchronization

KTSync clears barcode data stored in the KDC’s memory once synchronization has

finished if this option is enabled.

 Append data to file

KTSync appends synchronized data to existing file specified on destination. If file doesn’t exist then

KTSync creates a new file.

 Attach serial number

The KTSync would add a KDC serial number to barcode data if this option is enabled. This option is

enabled by default and can’t be disabled.

 Attach time stamp

The KTSync would add timestamp to barcode data if this option is enabled. This option is enabled by

default and can’t be disabled.

 Attached barcode type

The KTSync would add barcode type to barcode data if this option is enabled. This option is enabled by

default and can’t be disabled.

 Serial number

When“Attach serial number” is enabled, this option determines when to attach serial number. “Start

of record” means to attach at the front of record and “End of record” means to attach to the end of

record.

 Data order

This option specifies the order of data (Barcode Type, Barcode Data and Timestamp) in the record.

 Data delimiter

This option is used to select a character to be added between barcode data, serial number and

timestamp and/or barcode type. User can select one of the following: “None”, “Tab”, “Space”, ‘Comma”

and “Semicolon” as the data delimiter. The “Comma” is selected by default and can’t be changed.

 Record delimiter

This option is used to select a character to be added at the end of the barcode record. User can

selectone of “None”, “CR”, “LF”, TAB”, and “CR&LF” as the record delimiter.The “CR&LF” is selected

by default and can’t be changed.

 Non-English keyboard