User's Manual

KDC350 User Manual

4. BLUETOOTH - KDC200/250/300/350/400

The KDC200/250/300/350/400 support HID (Human Interface Device) normal, HID iOS, SPP (Serial Port

Profile) and SPP2.0 profiles. KDC200i/250i/300i/350i/400i support SPP and iPhone(Made for iPhone)

profiles. They are compatible with the following Bluetooth stacks.

 BlueSoleil

 Broadcom (Widcomm)

 Microsoft Windows XP, Vista, 7, and Mobile5.0+

 Toshiba

KDC200/250/300/350 can configure Bluetooth options using KDC menu and special barcodes. KDC400 can

configure Bluetooth options using PC KTSync and special barcodes.

Bluetooth Config

4.1 ConnectDevice

KDC supports both Serial Port Profile (SPP) and Human Interface Device Profile (HID). User can choose

SPP2.0, SPP(2.1), HID normal, HID iOS profiles to communicate with the host device. Additional iPhone

(Made for iPhone) option is available for KDC200i/KDC250i/300i/350i/400i models.

User can connect and disconnect Bluetooth connection with the host device by pressing Up and Down key if

BT Toggle option in BT Config menu is enabled. It normally takes 3 seconds to connect and 1 second to

disconnect.

This is a very useful feature for iPhone and iPad application. User can enable and disable iPhone and iPad

soft key instantly using this BT Toggle option.

Up key shows Bluetooth connection status and Down key shows time if KDC is connected using SPP profile.

[NOTE] User should unpair the KDC first from the Bluetooth host to change the Connect Device

setting on the scanner to other Bluetooth profile.

4.2 Auto Connect

This feature allows the KDC to connect automatically to the host device when the KDC is powered on.

IMPORTANT: Until the ho st device a nd KDC have b een fully tested, it is stron gly recommended that thi s

feature be set to Disable because a host device that does not support this feature can cause problems such

as power loss or upload delays.

[Note] KDC tries to connect automatically to the host 10 times during two minutes if Bluetooth power is ON,

Bluetooth is disconnected, Auto Connect is enabled and system Sleep Timeout is set to 5 seconds

4.3 Auto Power On

The Auto Power On option allows the KDC to automatically power on Bluetooth when the SCAN