User's Manual

KDC350 User Manual

3.8 Replace Battery

KDC200 comes with a rechargeable, Lithium-Polymer battery. The battery is recharged from any USB

port and can be recharged about 300 times before it needs to be replaced.

KoamTac recommends replacing the battery every six months as a declining battery will cause

noticeable performance degradation in KDC200. Replacement batteries can be purchased from a

KoamTac distributor. Batteries should be disposed of properly.

Step One - Place KDC200 face down on a firm surface. On the back, locate the small black screw in the

middle of KDC. This screw secures the battery cover.







Step Two - Press a small Phillips head screwdriver firmly into the screw while simultaneously turning

counterclockwise and loosen the screw. The battery cover will pop open. Remove the cover, keeping

the screw intact. Store cover with screw in a safe place for later.

Step Three - Gently lift the battery to locate a wire connector underneath the battery. The wire

connector is attached to the red and black wires on the battery. It is also attached to a connector on

KDC. Remove the battery using a flat head screwdriver to disengage the connectors, being careful not to

damage the connector on KDC.

Step Four – Use a small flat head screwdriver to reattach the new battery. Connect the white connector

attached to the red and black wires on the replacement battery to the connector on the KDC. Gently

press the battery down, fitting it inside the KDC. Replace the battery cover. With the Phillips head

screwdriver securely tighten the battery cover screw.

Step Five – The replacement battery must be charged before KDC can be used.