User's Manual

KDC User Manual
46
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
1
Unscrew the screw indicated by the arrow.
2
Remove the battery cover by pulling it
down.
3
Remove the battery.
Pull out the 2 pin connecter gently.
power is on. When you turn off your KDC30, you will hear a beep sound after you press
DOWN and SCAN buttons simultaneously.
Replace Battery 3.8
KDC comes with a rechargeable, Lithium-polymer battery. The battery is recharged from
any USB port or KDC charging cradle and can be recharged about 300 times before it
needs to be replaced. KoamTac recommends replacing the battery every six months as
a declining battery will cause noticeable performance degradation in KDC. Replacement
batteries can be purchased from a KoamTac distributor. Batteries should be disposed
properly according to the WEEE regulation. The steps for replacing the battery are as
follows.
1. Disassemble the KDC back cover by unscrewing the middle screw.
2. Remove old battery and replace with new battery.
3. Reassemble the back cover.
Figure 12 - Replacing Battery