User's Manual

KDC User Manual

Revision 3.05.R6

 NOTE: This Suffix option is different from the Suffix option in KTSync

which appends the suffix to data during synchronization.

 AIM ID - Allows you to add AIM ID to scanned data which can then be stored

in KDC or wedged to the host. AIM ID must be defined in data format menu

of KTSync. AIM ID is either added to the end of Prefix or Suffix.

 Partial Data: Allows you to store and/or transfer partial data. User defines the

start position and number of characters to be stored and/or transferred.

o Select the x characters from y position

- Set Partial Data Start Position to y, Partial Data Length to x, Partial

Data Action to Select

- Partial Data Length 0 means to select all characters from y position.

o Erase the x characters from y position

- Set Partial Data Start Position to y, Partial Data Length to x, Partial

Data Action to Erase

- Partial Data Length 0 means to erase all characters from y position.

Handshake - KDC provides Handshake mode when Data Format is set to Packet Data.



Handshake Mode will increase the reliability of barcode data transmission.



The default mode for Handshake is Disabled.



Data transmission speed is slower when Handshake Mode is Enabled.

Terminator – KDC supports various termination characters when the Data Format mode

is set to Barcode Only. This option allows you to select <NONE>, <CR>, <LF>,

<CR+LF>, or <TAB> as the termination character. The default terminator is <CR+LF>.

Up/Down/Left/Right arrow terminator is also available for HID mode.

Chk Duplicate – This option allows you to prevent collecting duplicated data.

3.3.5 BT Config Menu

The KDC supports Bluetooth Ver2.1+EDR. Before utilizing the advantages of Bluetooth

functionality with the KDC, you should become familiar with Bluetooth connectivity and

its impact on your host environment.