User's Manual

KDC250 User Manual
39
GPS Config - KDC250
z GPS Power
o Enable or Disable GPS Power
z Power Mode
o Normal or Power Save
z Bypass Data
o Enabled or Disabled
z Acquire Test
o Acquiring time test of GPS signal
z Reset GPS
o Reset GPS parameters
System Menu
z Memory Status: Checks the number of stored barcodes and memory usage.
z Reset Memory: Resets KDC memory by erasing all stored barcodes, application and BT registry.
z Auto Erase: Erases all stored barcodes upon reaching buffer full condition if Enabled is selected
z Sleep Timeout: Sets amount of time KDC waits, when not being used, before going to sleep.
z Auto Power Off (KDC250 only)
o Bluetooth: Enabled/Disabled
o GPS: Enabled/Disabled
o Power Off Time:0(Never), 5, 10, 20, 30, 60, 120 seconds
z Date/Time: Sets the date and time of KDC which can also be set using KTSync
®
z Battery: Shows current status of battery power level.
z Version: Shows KDC firmware version and serial number.
z Button Lock: Locks or unlocks KDC scan and scroll buttons.
z Beep Sound: Enables or disables KDC beep sound.
z Auto Exit: Enables KDC to automatically exit KDC Menus.
z Port Status: Enables or disables KDC port messages.
z Display Format: Selection of display format - Time & Battery, Type & Time, Type & Battery, or
Memory Status
z Menu Barcode: Enables or disables Honeywell special barcodes
z Scrolling : Enables or disables display scrolling for a barcode with more than 40 characters
z Brightness: Adjusts display brightness
z Factory Default: Resets KDC options to factory default settings.