User's Manual

KDC250 User Manual
38
BT Config Menu - KDC200 / KDC250 / KDC300
The KDC supports Bluetooth Ver2.1+EDR. Before utilizing the advantages of Bluetooth functionality with
the KDC, you should become familiar with Bluetooth connectivity and its impact on your host environment.
To configure your KDC for Bluetooth functionality, you must use the KDC Menus. To access the menus,
simultaneously press the UP and DOWN scroll buttons on the side of the KDC. Use the DOWN button to
scroll to Bluetooth then press the Scan button.
Below is a listing of the Bluetooth options and their settings. The default settings for these options have
been set to increase the usability of Bluetooth technology without compromising the KDC battery usage.
IMPORTANT: We strongly recommend NOT changing these settings until you have fully tested the
Bluetooth connection between the KDC and the host device.
For more detailed information regarding Bluetooth functionality with the KDC, please refer to Chapter 4.
z ConnectDevice – Only applicable to KDC200i and KDC300i
z Auto Connect - Enabled or Disabled
z Auto Power On - Enabled or Disabled
o PWR On Time – Disabled, 1 to 10 seconds
z Auto Power Off - Enabled or Disabled (KDC250 should use option in system menu)
o Beep Warning - Enabled or Disabled
o PWR Off Time - 1 to 30 Minutes
z PowerOff Msg – Enabled or Disabled
z MAC Address – 12 characters Bluetooth MAC Address
z FW Version – Display Bluetooth Firmware Version
z Wakeup Nulls – Enabled or Disabled
z Autolock Time – 0, 1, 2, 3, 4, 5, 10, 15 minutes
z BT Toggle – Enable or Disable HID soft keyboard or iPhone mode connection On/Off toggle.
z HID Keyboard – English or German
`
BT Service - KDC200 / KDC250 / KDC300
z Power
o Enable or Disable Bluetooth Power
z Pairing Mode
o KDC enters pairing mode so that host Bluetooth device can search KDC.
o KDC exits pairing mode either by pressing the scan button or it fails to pair with Bluetooth host
device in 90sec.
z Discovering
o Search neighborhood Bluetooth devices
z Connecting To
o Inquiry to registered Bluetooth devices
z HID Sync
o KDC transmits all stored data to the host over HID profile if HID Sync option is enabled