User's Manual

KD C2 0 0 Use r M a n u a l
17
PairingKDC200toHostDevice
User should pair KDC200 with Host Device first. This paring process doesn’t have to be repeated once Host
device recognizes KDC200.
User can set KDC200 to paring mode by selecting Pairing menu.
z “Paring started” message will be displayed once entering pairing mode.
z Enter PIN “0000” once requested by Host
z “Pairing success” message is displayed once host sets up Bluetooth connection successfully before
pairing timeout (60sec).
z “Pairing failed” message is displayed if failed to setup a Bluetooth connection with Host.
 User can ignore this message if Host shows “Connected” message
 KDC200 doesn’t show “Pairing success” message unless Host opens corresponding Bluetooth
COM port
ConnectingKDC200toHostDevice
User should connect KDC200 to host device before using Bluetooth feature. Please refer to host device manual
for the proper Bluetooth connection procedure.
KDC200 would display “Bluetooth connected” message once connected with host device.
AutoConnectingKDC200toHostDeviceonPowerOn
KDC200 can be connected to host device automatically upon Power On Bluetooth if Auto Connect is Enabled.
The default is Disabled and discouraged to use this feature unless fully tested with host device.
Some host devices do not support this feature and will result delay and power loss if Enabled but not connected
automatically.
BeepWarning
KDC200 beeps the Bluetooth connection status.
z High short beep tone will be played once Bluetooth is connected.
z Low short beep tone will be played once Bluetooth is disconnected.