User's Manual
Battery % left
Version FW version. Serial Number
Factory Default Restore factory default settings
ViewDataMenu
User can browse and delete scanned barcode in View Data menu.
SetBarcodesMenu
KDC200 supports most of popular barcode symbologies. However, it is important to select only the required
symbologies to provide the best scan performance. Please refer to Appendix A for the details of supporting
symbologies.
BarcodeOptionsMenu
KDC200 supports various barcode options including transmission of start and stop characters, symbology
conversion, verification of optional check character, and transmission of check digit. Please refer Appendix A
for the details of each option.
ScanOptionsMenu
z Scan Angle: User can control the laser beaming angle. Wide is 54
o
and Narrow is 27
o
. Default is Wide.
z Filter: User may use Higher filter mode for poor quality barcode. Default is Normal
z Timeout: User can set scanning timeout up to 10 sec. Default timeout is 2 sec.
z Minimum barcode length: User can set the smallest barcode size up to 36. It is strongly recommended
to maximize the minimum length to prevent possible wrong readings. Default is 4.
z Security Level: Higher security level provides more reliable readings with some performance
degradation. It is recommend to increase the security level for poor quality barcodes. Default is 1.
DataProcessMenu
Wedge / Store
- KDC200 provides three modes of data transmission.
z Wedge Only: KDC200 doesn’t store scanned barcode in the memory and just transmits it to the host
z Wedge & Store: KDC200 stores scanned data in the memory and transmits it to the host
z Store Only: KDC200 stores scanned data in the memory but doesn’t transmit it to the host.
z Wedge & Store if Sent: KDC200 stores scanned data in the memory if it transmits to the host