User's Manual

오류 ! 스타일이 정의되어 있지 않습니다 .
BasicOperation
Readingbarcodes
Point the KDC100 to the barcode and press the trigger key.
A High beeper tone will be heard upon a successful scan.
The front panel LED will illuminate in green.
The scanned barcode will be displayed, along with barcode type and time stamp.
When the barcode cannot be read, try the following:
z Check that the width of barcode label does not exceed the width of the light beam.
z Change the angle between the barcode and KDC100.
z Change the distance between the barcode and KDC100.
z Check option settings.
UploadbarcodedatatoPC.
Use the included Synchronization program to upload barcode data from KDC100 to your PC.
Start KTSync program
Configure Synchronization options
Execute Sync. Operation

KDC100Menus

The user can access menu selection mode by pushing both buttons on the right side of the KDC100
simultaneously. The table below summarizes the KDC 100 menus.
0123456789012
Code39
20061231:235959